Shift Cover - SSANGYONG 1999 Musso Service Manual

5B-36 MANUAL TRANSMISSION

SHIFT COVER

Disassembly Procedure
1. Using a hammer and a pin punch (3/16) remove the selector
arm roll pin.
2. Before removal, note the correct position of the interlock
plate and selector arm and remove the shift shaft.
3. Check and clean all removed parts and replace if necessary.
Assembly Procedure
1. If the shaft cup plug was removed, apply plug outer surface
with sealer and install it into the cover.
2. Install the fork pads and selector plates onto the 1-2 and 3-
4 shift forks.
3. Assemble the sift cover parts as follows :
Push the shift shaft into the cover until the front of the shaft
is at the inside of the cover.