Packet Transmission Process; Carrier Deference; Figure 9-3. Packet Transmission Process - Cirrus Logic EP93 Series User Manual

Arm 9 embedded processor family
Table of Contents

Advertisement

9.1.3 Packet Transmission Process

This section explains the complete packet transmission process as seen on the Ethernet line.
This process includes: carrier deference, back-off, packet transmission, transmission of EOF,
and SQE test. Refer to
Start of Transmit
Frame in fifo
Deference
Transmission
Transmission
Complete
Transmit EOF
Report Applicable
Transmit
Status
The Ethernet/ISO/IEC 8802-3 topology is a single shared medium with several stations. Only
one station can transmit at a time. The access method is called Carrier Sense Multiple
Access with Collision Detection (CSMA/CD). This method is a "listen before talk" mechanism
that has an added feature to end transmissions when two, or more, stations start
transmissions at nearly the same time.
The CSMA portion of this method provides collision avoidance. Each station monitors its
receiver for carrier activity. When activity is detected, the medium is busy, and the MAC
defers (waits) until the medium no longer has a carrier.

9.1.3.1 Carrier Deference

Refer to
Figure
layer immediately moves to the Carrier Deference State Diagram. The Carrier Deference
state is independent of entry into the state diagram. The MAC layer may enter the state
diagram in any of its five states. The MAC layer exits the Carrier Deference only from the IFG
DS785UM1
Figure
9-3.
The Packet Transmission Process
Carrier
Carrier Deference is
detailed in the next diagram.
Transmission ends with
either completion of the
frame, or a collision.
There was
a collision
Late
Transmit JAM
Collision
Report Applicable
Transmit
Status

Figure 9-3. Packet Transmission Process

9-4. Once sufficient bytes have been written to the transmit FIFO, the MAC
Copyright 2007 Cirrus Logic
1/10/100 Mbps Ethernet LAN Controller
The maximum number of
collisions is either 16 or 1
depending on the Onecoll bit
in the transmit descriptor.
Max
NO
number of
Collisions
?
?
YES
YES
Report Applicable
Transmit
Status
EP93xx User's Guide
NO
Wait for the duration
of the BackOff Timer
The backoff time is a computed
random number based on either
the standard algorithm or the
modified back-off algorithm.
See the ModBackoffE bit
in TxCTL.
9
9-5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EP93 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Ep9315Ep9301Ep9302Ep9307Ep9312

Table of Contents