Interface Vlan - Dell N1100-ON Reference Manual

protocol group
protocol vlan group show vlan private-
protocol vlan group
all
show dot1q-tunnel switchport dot1q
show interfaces
switchport

interface vlan

Use the interface vlan command in Global Configuration mode to enable L3
on a VLAN and enter VLAN Interface Configuration mode. Use the no form
of the command to disable routing on the VLAN.
Syntax
interface vlan {vlan-id}
no interface vlan { vlan-id }
• vlan-id—The ID of a valid VLAN (Range 1–4093).
Default Configuration
By default, Layer 3 is enabled on VLAN 1 on the N1100-
ON/N1500/N2000/N2100-ON Series switches. However, VLAN routing
interfaces do not route packets until an IP address is assigned to the VLAN
and IP routing is globally enabled. DHCP and Layer 3 are not enabled on
VLAN 1 by default for the N3000, N3100-ON, and N4000 Series switches.
DHCP is enabled on VLAN 1 by default for the N1100-
ON/N1500/N2000/N2100-ON switches. The N1100-ON does not support
routing.
Command Mode
VLAN Configuration or Global Configuration modes
show vlan
association subnet
vlan
switchport access
vlan
ethertype (Global
Configuration)
switchport general
forbidden vlan
switchport mode
switchport mode
dot1q-tunnel
switchport mode
private-vlan
switchport private-
vlan
switchport trunk
Layer 2 Switching Commands
vlan makestatic
vlan protocol group
vlan protocol group add
protocol
vlan protocol group
name
vlan protocol group
remove
790