Match Ip Address - Dell C9000 Series Reference Manual

match ip address

To match routes based on IP addresses specified in an access list, configure a filter.
C9000 Series
Syntax
match ip address prefix-list-name
To delete a match, use the no match ip address prefix-list-name command.
Parameters
prefix-list-name
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related
match interface
Commands
match ip next-hop
match ip route-source
routers.
match metric
Enter the name of configured prefix list, up to 140 characters.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters. Prior
to 7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— redistributes routes that match the next-hop interface.
— redistributes routes that match the next-hop IP address.
— redistributes routes that match routes advertised by other
— redistributes routes that match a specific metric.
Access Control Lists (ACL) 366