Ip Ecmp-Group - Dell Z9500 Command Reference Manual

ip ecmp-group

Enable and specify the maximum number of ecmp that the L3 CAM hold for a route, By default, when
maximum paths are not configured, the CAM can hold a maximum of 16 ecmp per route.
Z9500
Syntax
ip ecmp-group {maximum-paths | {number} {path-fallback}
To negate a command, use the no ip ecmp-group maximum-paths {number}
command.
Parameters
maximum-
paths
path-fallback
Defaults 16
Command CONFIGURATION
Modes
Command
Version
History
9.2(1.0)
9.0.0.0
8.3.10.0
Usage You must save the new ECMP settings to the startup-config (write-mem) then
Information reload the system for the new settings to take effect.
Related show ip cam linecard
Commands set of ports on a line card.
748
NOTE: While the seed is stored separately on each port-pipe, the same seed is
used across all CAMs.
You cannot separate LAG and ECMP but you can use different algorithms
across the chassis with the same seed. If LAG member ports span multiple
port-pipes and line cards, set the seed to the same value on each port-pipe to
achieve deterministic behavior.
If the hash algorithm configuration is removed, the hash seed does not go to
the original factory default setting.
Specify the maximum number of ECMP for a route. The
range is 2 to 64.
Use the keywords path-fallback to enable this feature. If
you enable the feature, re-enter this keyword to disable the
feature.
Description
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the S4810.
– Display content-addressable memory (CAM) entries for a
Equal Cost Multi-Path (ECMP)