Radius-Server Retransmit - Dell C9000 Series Reference Manual

If you configure the key parameter in the radius-server host command, the key
configured with the radius-server key command is the default key for all RADIUS
communications.
Related radius-server host
Commands

radius-server retransmit

Configure the number of times the switch attempts to connect with the configured RADIUS host server
before declaring the RADIUS host server unreachable.
C9000 Series
Syntax
radius-server retransmit retries
To configure zero retransmit attempts, use the no radius-server retransmit
command.
To return to the default setting, use the radius-server retransmit 3 command.
Parameters
retries
Defaults 3 retries
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.0
— configures a RADIUS host.
Enter a number of attempts that the system tries to locate a
RADIUS server. The range is from zero (0) to 100. The default is
3 retries.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Security 1957