Version
6.2.1.1
tacacs-server host
Specify a TACACS+ host.
C9000 Series
Syntax
tacacs-server host {hostname | ipv4-address | ipv6-address} [port
number] [timeout seconds] [key key]
Parameters
hostname
ipv4-address |
ipv6-address
port number
timeout seconds
key key
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.4.1.0
Description
Introduced on the E-Series.
Enter the name of the TACACS+ server host.
Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) of
the TACACS+ server host.
(OPTIONAL) Enter the keyword port then a number as the port
to be used by the TACACS+ server. The range is from zero (0) to
65535. The default is 49.
(OPTIONAL) Enter the keyword timeout then the number of
seconds the switch waits for a reply from the TACACS+ server.
The range is from 0 to 1000. The default is 10 seconds.
(OPTIONAL) Enter the keyword key then a string up to 42
characters long as the authentication key. This authentication
key must match the key specified in the tacacs-server key
for the TACACS+ daemon.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for IPv6.
Security
1961