003-761 Incorrect Paper Tray Size Rap; 003-763 Adjustment Chart Rap - Xerox workcentre 5335 series Service Manual

003-761 Incorrect Paper Tray Size RAP

The paper size in the tray selected by auto tray switching APS differs from the paper size in the
tray selected at the tray selection. When Cover Text Tray or Interleaf +Nset Tray is selected by
APS, the paper size for that tray is different from that for Cover Tray or OHP Tray.
Procedure
• Ask customer to either change the paper size for the tray, or change the paper type prior-
ity setting. Change Job Startup parameters such as Tray No., Paper size etc. and retry.
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - reload Software
• Ensure that the Paper Tray Settings are set properly.
Initial Issue
WorkCentre 5335 Family Service Documentation

003-763 Adjustment Chart RAP

When Automatic Gradation Correction is performed the patch for position detection on the doc-
ument is not available.
Procedure
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - reload Software
• Properly set the Automatic Gradation Correction Chart for automatic tone correction.
• Perform White Reference and CCD Calibration
(GP 16)
07/2011
2-43
BUS Updated 12/2011
(GP 16)
ADJ 6.6.
Status Indicator RAPs
003-761, 003-763