003-981 Staple Size RAP
Staple size error (Copy APS). Stapling could not be done for the selected paper size.
Procedure
•
Specify a Staple position again or cancel Staple, and execute the same job again.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - reload Software
Initial Issue
WorkCentre 5335 Family Service Documentation
003-982 IITsc HDD Access Error RAP
HD-FULL was detected with no pages stored. An error where the FULL is not cleared even
after some time has passed.
Procedure
•
Disconnect then reconnect the HDD, ESS, MCU all PWBs connected to them (RAM,
Firmware module, EEPROM)
•
Perform
(GP
16)
tions
•
If the problem persists, expand the HDD partition size of the Copy service.
•
If the problem persists, go to
•
Check the sw version of the controller sw - reload Software
•
Replace HDD
•
Replace ESS PWB
DIMM.
07/2011
2-61
BUS Updated 12/2011
GP 14
- only the first three parts - make sure to follow sequence and heed cau-
Hard Disk Failure Prediction
(PL
35.2)
(PL
35.2) (If not fixed by this, reinstall the original ESS PWB and RAM
Test.
(GP
16)
Status Indicator RAPs
003-981, 003-982