016-313 Hybrid Water Mark Setting Mismatch Rap; 016-314 Hybrid Water Mark Not Exist Rap - Xerox workcentre 5335 series Service Manual

016-313 Hybrid Water Mark Setting Mismatch RAP

This is a configuration error type of fault related to the Secure Watermark Kit.
Procedure
Check the following:
1. Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
2. In UI Diagnostics, (Accessing UI Diagnostics) ensure that the password for the Secure
Watermark Kit, Software Option is installed.
3. Ensure that the HDD (PL 35.2) is installed and operational.
4. Confirm System Memory is sufficient for this option (768MB).
5. Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
6. Check the sw version of the controller sw - update if required
7. Replace RAM DIMM on ESS PWB (PL
8. Replace ESS PWB (PL 35.2) (If not fixed by this, reinstall the original ESS PWB and RAM
DIMM.)
Initial Issue
WorkCentre 5335 Family Service Documentation
35.2)
BUS Updated 12/2011

016-314 Hybrid Water Mark Not Exist RAP

BSD-ON: BSD 16.1 - ESS
SW Option Fail (HybridWaterMark Not Exist). While SW option function is enabled, simulta-
neous duplex scanning with 2 HWM boards (for Side1 and Side2) is conducted using the com-
bination of DADF:PF1.5/IIT:PF1-BW. When reproduction limitation code is detected, the
function is reflected only on page for which the code is detected.
Procedure
• Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
• Power OFF/ON.
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - update if required
• Replace RAM DIMM on ESS PWB
• Replace ESS PWB (PL 35.2) (If not fixed by this, reinstall the original ESS PWB and RAM
DIMM.)
07/2011
016-313, 016-314 Hybrid Water Mark Not Exist RAP
2-151
(PL 35.2)
Status Indicator RAPs