003-753 300Dpi Cannot Be Scanned Rap; 003-754 Scan Recoverable Error Rap - Xerox workcentre 5335 series Service Manual

003-753 300dpi Cannot be Scanned RAP

BSD-ON: BSD 3.5 - ESS-DADF Communication
This status code is displayed if - Unscannable 300dpi or higher resolution detected after DADF
Mix Duplex Mode Job is accepted.
Procedure
• Perform scanning below 200 dpi resolution.
Or perform scanning in other than mixed mode.
• If powering OFF then ON does not resolve the problem, perform the following:
1. Check the connection between IIT PWB and ESS PWB.
2. Check the sw version of the controller sw - reload Software
3. Replace IIT PWB (Switch the EEPROM)
4. Replace ESS PWB (PL 35.2).
Status Indicator RAPs
003-753, 003-754
(GP 16)
(PL 1.6)
BUS Updated 12/2011

003-754 Scan Recoverable Error RAP

BSD-ON: BSD 3.5 - ESS-DADF Communication
Recoverable high-compression Scan error
Procedure
• Retry the job.
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - reload Software
07/2011
2-40
(GP 16)
Initial Issue
WorkCentre 5335 Family Service Documentation