Table of Contents
Advertisement
005-916 DADF APS Sensor 2 Static Jam RAP
BSD-ON:
BSD 5.4 - Document Feed (1 of 2)
The DADF APS Sensor 2 turns ON at the timings below.
1.
When Power is ON
2.
At Feeder Cover Interlock Close
3.
At Platen Interlock Close
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Procedure
Check the following:
•
Check the DADF APS Sensor 2 for remaining paper, the Actuator for return failure, for-
eign substances, contamination on sensors, and etc.
•
DADF APS Sensor 2:
Component Control
•
Check the sw version of the controller sw - update if required
•
If the problem persists, check the circuit between the DADF APS Sensor 2 and the DADF
PWB. If no problems are found, replace the DADF PWB
Status Indicator RAPs
005-916, 005-917
[005-219]
(PL
51.17)
(PL
51.2).
BUS Updated 12/2011
005-917 DADF APS Sensor 3 Static Jam RAP
BSD-ON:
BSD 5.4 - Document Feed (1 of 2)
The DADF APS Sensor 3 turns ON at the timings below.
1.
When Power is ON
2.
At Feeder Cover Interlock Close
3.
At Platen Interlock Close
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Procedure
Check the following:
•
Check the sw version of the controller sw - update if required
•
Check the DADF APS Sensor 3 for remaining paper, the Actuator for return failure, for-
eign substances, contamination on sensors, and etc.
•
DADF APS Sensor 3:
Component Control
•
If the problem persists, check the circuit between the DADF APS Sensor 3 and the DADF
PWB. If no problems are found, replace the DADF PWB
•
Check the sw version of the controller sw - update if required
07/2011
2-78
[005-220]
(PL
51.17)
(PL
51.2).
Initial Issue
WorkCentre 5335 Family Service Documentation
Advertisement
Table of Contents
