Table of Contents
Advertisement
C
D
Measure the voltage between Finisher PWB P/J8705-1 (+) and GND (-). The voltage is
approx. +24VDC.
Y
N
Go to
Integrated Finisher Wirenets
replace the Finisher PWB
(PL
22.7).
Enter [012-013], measure the voltage between Finisher PWB P/J8705-2 (+) and GND (-
). The voltage changes.
Y
N
Replace the Finisher PWB
(PL
22.7).
Replace the Sub Paddle Solenoid
(PL
Check the wires and connectors for an intermittent open or short circuit. If the problem contin-
ues, replace the Finisher PWB
(PL
22.7).
Initial Issue
WorkCentre 5335 Family Service Documentation
and check the +24VDC circuit. If the circuit is OK,
22.3).
BUS Updated 12/2011
012-152 (Integrated Finisher) Compiler Exit Sensor ON
Jam RAP
BSD-ON:
BSD 12.3 Integrated Finisher Transportation
The Compiler Exit Sensor does not turn On within a specified time after receiving the Sheet
Exit command (the paper to be ejected has turned On the IOT Exit Sensor 1).
Initial Actions
•
Check the Compiler Exit Sensor is properly installed and free from foreign objects and
that the actuator is not broken.
•
Power Off/On.
Procedure
Check the specifications of paper. Paper is in spec.
Y
N
Replace the paper with new paper that is in spec.
Check the condition of the paper. The paper is in normal condition without any problem
that causes the paper to be bent or caught.
Y
N
Resolve any problem that causes the paper to be bent or caught.
Check the transport path for a foreign object, deformed part, and paper dust. The
path is in normal condition with no foreign object, deformed part and paper dust.
Y
N
Repair the deformed part(s) and remove the foreign object(s) and paper dust.
Check the Transport Roll for wear, deterioration and paper dust. The Transport Roll is in
normal condition.
Y
N
Remove the paper dust and replace the worn or deteriorated Transport Roll.
Check the drive mechanism to the Transport Roll for a deformed parts, broken parts, and/or
belt damage. The drive mechanism free from defects.
Y
N
Repair defects or damage to the drive mechanism.
Check that the Finisher is installed properly. The Finisher is properly installed and properly
connected to the IOT.
Y
N
Reinstall the Finisher properly.
Enter
Component Control
[012-150]. Actuate the Compiler Exit Sensor. The
changes.
Y
N
Check the connections of
P/J8709
connected.
Y
N
Connect
P/J8709
and
P/J8728
A
B
07/2011
012-151 (Integrated Finisher), 012-152 (Integrated
2-89
and P/J8728.
P/J8709
and
P/J8728
are securely
securely.
Status Indicator RAPs
transport
display
Advertisement
Table of Contents
