003-931 400 Dpi Scan Rap; 003-932 600 Dpi Scan Rap - Xerox workcentre 5335 series Service Manual

003-931 400 DPI Scan RAP

BSD-ON: BSD 3.5 - ESS-DADF Communication
For scanning in the DADF mix duplex mode, 400dpi and 600dpi are not available. Because
Page Memory is not enough, a selected resolution is not available for scanning a A3 docu-
ment. It is available for scanning a A4/B4 document.
Procedure
• Verify scan settings are correctly set (at below 400dpi) and menu selections are correctly
set. Increase Page Memory (PL 35.2).
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - reload Software
Status Indicator RAPs
003-931, 003-932

003-932 600 DPI Scan RAP

BSD-ON:
For scanning in the DADF mix duplex mode, 600dpi is not available.
Procedure
• Verify scan settings (scanning at below 600dpi) are correctly set and menu selections are
correctly set. Increase Page Memory
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - reload Software
(GP 16)
07/2011
2-46
BUS Updated 12/2011
BSD 3.5 - ESS-DADF Communication
(PL 35.2).
WorkCentre 5335 Family Service Documentation
(GP 16)
Initial Issue