003-311 Iit Cdi Interface Mismatch Rap; 003-318 Iit Software Rap - Xerox workcentre 5335 series Service Manual

003-311 IIT CDI Interface Mismatch RAP

BSD-ON: BSD 3.3 - ESS-IIT Communication
BSD-ON: BSD 16.1 - ESS
Error detected when information sent to controller from IIT via IIT CDI I/F during initialization of
controller is insufficient. (e.g. bad combination of controller SW and IIT SW)
Procedure
• Reload correct Controller and IIT Software
• Replace IIT PWB (Switch the EEPROM)
• Replace the ESS PWB (PL 35.2)
Initial Issue
WorkCentre 5335 Family Service Documentation
(GP 16).
(PL 1.6)
BUS Updated 12/2011

003-318 IIT Software RAP

BSD-ON: BSD 3.3 - ESS-IIT Communication
BSD-ON: BSD 16.1 - ESS
The IIT software is corrupt.
Procedure
• Ensure that the customer is programming a job within the parameters of the machine uti-
lizing the UI.
• Disconnect then reconnect the IIT, Control Panel, ESS, MCU all PWBs connected to them
(RAM, Firmware module, EEPROM)
• Check the sw version of the controller sw
• Reload Software (GP 16)
• Replace IIT PWB (Switch the EEPROM)
• If the problem persists, replace the ESS PWB
original ESS PWB and RAM DIMM.)
07/2011
2-23
(PL 1.6)
(PL 35.2). (If not fixed by this, reinstall the
Status Indicator RAPs
003-311 , 003-318