003-933 300 Dpi Scan Rap; 003-934 400 Dpi Scan Rap - Xerox workcentre 5335 series Service Manual

003-933 300 DPI Scan RAP

BSD-ON: BSD 3.5 - ESS-DADF Communication
Scanning in the DADF mix duplex mode, 300dpi, 400dpi and 600dpi are not available (when
the next document exists). Because Page Memory is insufficient, a selected resolution is not
available for scanning an A3 document. It is available for scanning an A4/B4 document.
Procedure
• Verify scan settings (Operate for scanning at below 300dpi) are correctly set and menu
selections are correctly set. Increase Page Memory
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - reload Software
Initial Issue
WorkCentre 5335 Family Service Documentation
(PL 35.2).
(GP 16)
07/2011
2-47
BUS Updated 12/2011

003-934 400 DPI Scan RAP

BSD-ON: BSD 3.5 - ESS-DADF Communication
When scanning in the DADF mix duplex mode, 400dpi and 600dpi are not available (when the
next document exists). Because Page Memory is insufficient, a selected resolution is not avail-
able for scanning an A3 document. It is available for scanning an A4/B4 document.
Procedure
• Verify scan settings (at below 400dpi) are correctly set and menu selections are correctly
set. Increase Page Memory (PL 35.2).
• Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
• Check the sw version of the controller sw - reload Software (GP 16)
Status Indicator RAPs
003-933, 003-934