Mitsubishi Electric RD77MS2 User Manual page 95

2-axis circular interpolation control with center point designation (INC circular)
■Operation chart
In the incremental system, 2-axis circular interpolation control with center point designation, positioning is carried out from the
current stop position (start point address) to a position at the end of the movement amount set in "[Da.6] Positioning address/
movement amount", in an arc path having as its center the address (arc address) of the center point set in "[Da.7] Arc
address".
Forward direction
Start point address
(current stop position)
Reverse direction
Reverse direction
Positioning of a complete round with a radius of the distance from the start point address to the arc center point can be carried
out by setting the movement amount to "0".
Forward direction
Reverse direction
Reverse direction
In circular interpolation control with center point designation, an angular velocity is calculated on the assumption that
operation is carried out at a command speed on the arc using the radius calculated from the start point address and center
point address, and the radius is compensated in proportion to the angular velocity deviated from that at the start point.
Thus, when there is a difference (error) between a radius calculated from the start point address and center point address
(start point radius) and a radius calculated from the end point address and center point address (end point radius), the
composite speed differs from the command speed as follows.
Start point radius > End point radius
Start point radius < End point radius
Movement by circular interpolation
Radius
Arc center point
(Arc address)
Movement amount to the end point
Arc center point
(Arc address)
Movement amount = 0
Forward direction
As compared with the speed without error, the speed becomes slower as end point address is reached.
As compared with the speed without error, the speed becomes faster as end point address is reached.
Movement amount to the end point
Forward direction
3 MAJOR POSITIONING CONTROL
3.2 Setting the Positioning Data
3
93