[Cd.42] Stop command processing for deceleration stop selection
• Sets the stop command processing for deceleration stop function (deceleration curve re-processing/deceleration curve
continuation).
Fetch cycle: At deceleration stop causes occurrence
■Setting value
• Set with a decimal.
Setting
K
value
• Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 392 Control data
12 DATA USED FOR POSITIONING CONTROL
506
12.8 Control Data
Stop command processing for
deceleration stop selection
0: Deceleration curve re-processing
1: Deceleration curve continuation
Need help?
Do you have a question about the RD77MS2 and is the answer not in the manual?