Servo driver VCII series manufactured by Nikki Denso Co., Ltd.
The direct drive DISC/iD roll/Servo compass/Linear stages, etc. manufactured by Nikki Denso Co., Ltd. can be controlled
by connecting with the servo driver VC series manufactured by the company using SSCNET or SSCNET/H.
Contact to Nikki Denso overseas sales office for details of VC series.
The system configuration using VC series is shown below.
Simple Motion module
* MR-JE-_B can be connected via SSCNET
To connect VC series, set the following parameters.
n: Axis No.-1
00080102H: VC (Manufactured by Nikki Denso Co., Ltd.) (For linear stage)
00080107H: VC (Manufactured by Nikki Denso Co., Ltd.) (For direct drive motor)
00081000H: VC (Manufactured by Nikki Denso Co., Ltd.)
*1 For SSCNET connection
*2 For SSCNET/H connection
Parameters set in VC series are not controlled by the Simple Motion module.
Appendix 3 Compatible Devices with SSCNETIII(/H)
Compatible Devices with SSCNETIII(/H)
Servo amplifier *
RD77MS2: Up to 2 axes
RD77MS4: Up to 4 axes
RD77MS8: Up to 8 axes
RD77MS16: Up to 16 axes
Default value Buffer memory address