[Da.14] Parameter
Set the value as required for "[Da.13] Special start instruction".
[Da.13] Special start
instruction
Block start (Normal start)
Condition start
Wait start
Simultaneous start
Repeated start (FOR loop)
Repeated start (FOR condition)
12 DATA USED FOR POSITIONING CONTROL
462
12.5 Block Start Data
Setting
Setting details
value
Not used. (There is no need to set.)
1 to 10
Set the condition data No. (Data No. of "condition data" is set up for the condition judgment.) (Refer to
Page 463 Condition Data for details on the condition data.)
0 to 255
Set the number of repetitions.
1 to 10
Set the condition data No. (Data No. of "condition data" is set up for the condition judgment.)