Samsung S5PC100 User Manual page 15

PRODUCT OVERVIEW
♦ High speed synchronous serial interface
•
CompactFlash Controller
♦ Supports Compact Flash Specification Revision 3.0
♦ Compatible with the ATA/ATAPI-6 standard
•
IrDA
♦ Dedicated IrDA for v1.1 (1.152Mpbs and 4Mpbs)
♦ SIR(111.5kbps) mode is supported by the URAT IrDA 1.0 block
♦ Internal 64-byte Tx/Rx FIFO
•
UART
♦ 4-channel UART with DMA-based or interrupt-based operation
♦ Supports 5-bit, 6-bit, 7-bit, or 8-bit serial data transmit/receive
♦ Supports external clock for the UART operation (UCLK)
♦ Programmable baud rate
♦ Supports IrDA 1.0 SIR (115.2Kbps) mode
♦ Loop back mode for testing
♦ Non-integer clock divides in Baud clock generation (BRM)
•
USB OTG 2.0
♦ Complies with the USB OTG 2.0
♦ Supports high speed up to 480Mbps
♦ On-chip USB transceiver
•
USB Host 1.1
♦ Complies with the USB Host 1.1
♦ Supports full speed up to 12Mbps
♦ On-chip USB transceiver
•
CAN Interface
♦ Supports CAN protocol version 2.0 part A and B
♦ Bit rates up to 1 Mbit/s
♦ Support Programmable FIFO mode and programmable loop-back mode for self-test
♦ Support Maskable interrupt
♦ Support DAR mode for time triggered CAN applications
♦ 8-bit non-multiplex Motorola HC08 compatible module interface
♦ Support two 16-bit module interfaces to the AMBA APB bus from ARM
1.1-12
S5PC100 USER'S MANUAL (REV1.0)