Samsung S5PC100 User Manual page 777

S5PC100 USER'S MANUAL (REV1.0)
DSIM_CONFIG
AutoMode
HseMode
HfpMode
HbpMode
HsaMode
MainVc
SubVc
Reserved
Bit
[24] Auto vertical count mode
In Video mode, Vertical line transition use line counter
configured by VSA, VBP and Vertical resolution. If this
bit is set to '1', line counter does not use VSA and VBP
registers.
0 = Configuration mode
1 = Auto mode
In command mode, this bit is ignored.
[23] In Vsync pulse and Vporch area, MIPI DSI master
transfers only Hsync start packet to MIPI DSI slave at
MIPI DSI spec 1.1r02. This bit is optional function to
transfer Hsync end packet in Vsync pulse and Vporch
area.
0 = Disables to transfer
1 = Enables to transfer
In command mode, this bit is ignored.
[22] HFP disable mode. If this bit set, DSI master ignores
HFP area in Video mode.
0 = Enables
1 = Disables
In command mode, this bit is ignored.
[21] HBP disable mode. If this bit set, DSI master ignores
HBP area in Video mode.
0 = Enables
1 = Disables
In command mode, this bit is ignored.
[20] HSA disable mode. If this bit set, DSI master ignores
HSA area in Video mode.
0 = Enables
1 = Disables
In command mode, this bit is ignored.
[19:18] Virtual channel number for main display
[17:16] Virtual channel number for sub display
[15] Reserved
Description
MIPI DSIM
R/W Reset Value
R/W 0
R/W 0
R/W 0
R/W 0
R/W 0
R/W 0
R/W 0
- -
8.7-21