Samsung S5PC100 User Manual page 781

S5PC100 USER'S MANUAL (REV1.0)
3.2.9 Main display Hporch register (DSIM_MHPORCH, R/W, Address = 0xECB0_0x20)
DSIM_MHPORCH
MainHfp[15:0]
MainHbp[15:0]
3.2.10 Main display Sync Area register (DSIM_MSYNC, R/W, Address = 0xECB0_0x24)
DSIM_MSYNC
MainVsa[9:0]
Reserved
MianHsa[15:0]
3.2.11 Sub display Image resolution register (DSIM_SDRESOL, R/W, Address = 0xECB0_0x28)
DSIM_SDRESOL
SubStandby
Reserved
SubVResol[10:0]
Reserved
SubHResol[10:0]
Bit
[31:16] Horizontal Front Porch width for Video mode
HFP is specified using along blank packet.
These bits are word counts for blank packet in HFP.
In Command mode, these bits are ignored.
[15:0] Horizontal Back Porch width for Video mode
HBP is specified using along blank packet.
These bits are word counts for blank packet in HBP.
In Command mode, these bits are ignored.
Bit
[31:22] Vertical Sync Pulse width for Video mode
(line count)
In command mode, these bits are ignored.
[21:16] Reserved
[15:0] Horizontal Sync Pulse width for Video mode
HSA is specified using along blank packet.
These bits are word counts for blank packet in HSA.
In command mode, these bits are ignored.
Bit
[31] Standby for receiving DISPCON output in Command
mode after setting all configuration
0 = Not ready
1 = Standby
Standby should be set after configuration( resolution,
reqtype, pixelform, and etc.) is set for command mode.
In Video mode, this bit is ignored.
[30:27] Reserved
[26:16] Vertical resolution (1 ~ 1024)
[15:11] Reserved
[10:0] Horizontal resolution (1 ~ 1024)
Description
Description
Description
MIPI DSIM
R/W Reset Value
R/W 0
R/W 0
R/W Reset Value
R/W 0
- -
R/W 0
R/W Reset Value
R/W 0
- -
R/W 0x300
- -
R/W 0x400
8.7-25