Ip Dos Scan Decay - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

IP Commands

ip dos scan decay

Sets the decay speed of the port scan penalty value for the switch when calculating DoS attacks.
ip dos scan decay decay_value
Syntax Definitions
decay_value
Defaults
parameter
decay_value
Platforms Supported
OmniSwitch 6250
Usage Guidelines
The port scan penalty value is reduced every minute by dividing by the amount set in using this command.
For example, if the decay value is set to 10, every minute the total port scan penalty value is divided by
10.
Examples
-> ip dos scan decay 10
Release History
Release 6.6.1; command was introduced.
Related Commands
ip dos scan threshold
show ip dos config
MIB Objects
alaDoSConfig
alaDoSPortScanDecay
OmniSwitch 6250 CLI Reference Guide
The decay value amount for reducing the port scan penalty. This value
can be any non-negative integer.
default
2
Sets the threshold for the port scan value, at which a DoS attack is
recorded.
Displays the configuration parameters of the DoS scan for the
switch.
November 2009 page 29-77