Inserting S8300 Server - Avaya G430 Deploying And Upgrading

Table 3: Permitted slots for Branch Gateway and EM200 media modules
Media module
MM710
MM710B
MM711
MM712
MM714
MM714B
MM716
MM717
MM720
MM721
MM722
S8300C or S8300D
Related links
Installing the media modules

Inserting S8300 Server

About this task
You can install the S8300D or S8300E server in slot V1 on the left side of the Branch Gateway.
Electrostatic alert:
Hold the module only by its edges to avoid damage from static electricity. Do not touch the top
or bottom of the circuit board. If possible, wear a wrist-strap and use an anti-static bag.
Caution:
The connector pins can be bent or damaged if the module is handled roughly, or if misaligned
and then forced into position.
Caution:
Separate ESD paths to the chassis ground connect to the media modules at the spring-loaded
captive screws. Use a screwdriver to ensure the captive screws are securely tightened to
prevent damage to the equipment.
Procedure
1. If you are installing an S8300D or S8300E server, remove the plate above slot V1
2. Remove the blank plate from slot V1.
July 2018
Permitted slots Description
V1-V3, V5-V8 1 T1/E1 ISDN PRI trunk port
V1-V3, V5-V8 1 T1/E1 ISDN PRI trunk port
V1-V3, V5-V8 8 universal analog ports
V1-V3, V5-V8 8 DCP telephone ports
V1-V3, V5-V8 4 analog telephone ports and 4 analog trunk ports
V1-V3, V5-V8 4 analog telephone ports, 4 analog trunk ports, and an
emergency transfer relay
V1-V3, V5-V8 24 analog ports
V1-V3, V5-V8 24 DCP telephone ports
V1-V3, V5-V8 8 ISDN BRI trunk or endpoint (telephone or data) ports
V1-V3, V5-V8 8 ISDN BRI trunk or endpoint (telephone or data) ports
V1-V3, V5-V8 2 ISDN BRI trunk ports
V1 Communication Manager server
on page 28
Deploying and Upgrading Avaya G430 Branch Gateway
Comments on this document? infodev@avaya.com
Installing the media modules
31