Copying The Firmware File To A Tftp Server Or An Ftp Server; Reviewing Safety Requirements; Verifying Equipment - Avaya IG550 Installing And Configuring

Copying the firmware file to a TFTP server or an FTP server

1. To load the firmware on a TGM550, place the firmware file on a TFTP or FTP server that is
connected to the customer's LAN.
A TFTP server can be a customer computer. A TFTP server can also be an S8300 Media
Server on the LAN or WAN of the customer on which the firmware has been uploaded to the
/tftpboot directory.
Note:
Use a Linux-based or a Unix-based TFTP server only if the customer already has
Note:
an existing one. In these cases, download the file to your laptop computer and
give the file to the customer for proper placement and execution. If the customer
does not have a TFTP server or an FTP server you can use, download a TFTP
server to your laptop to use with the firmware upgrades.

Reviewing safety requirements

1. See
General Safety Guidelines and Warnings on page 148

Verifying equipment

1. Verify that you have the following on site:
Electrostatic discharge (ESD) grounding strap (not provided)
●
For rack or wall installation, flathead and Phillips head screwdrivers appropriate for the
●
screws or anchors (not provided)
For the Communication Manager server, a license enabled for media gateway
●
announcements
A Juniper-approved Disk-on-Key (USB memory stick) that contains the JUNOS
●
configuration file.
.
Issue 1.1 May 2007 13