Enable Optic-Info-Update Interval - Dell MXL 10GbE Reference Manual

Command EXEC
Modes
Command
Version 9.5(0.0)
History
Version 8.3.16.1
Usage Users entering EXEC Privilege mode or any other configured privilege level can
Information access configuration commands. To protect against unauthorized access, use the
enable password command to configure a password for the enable command
at a specific privilege level. If no privilege level is specified, the default is privilege
level 15.
Related enable password
Commands
access a privilege level.

enable optic-info-update interval

Enable polling intervals of optical information updates for simple network management protocol (SNMP).
Syntax
enable optical-info-update interval seconds
To disable optical power information updates, use the no enable optical-
info-update interval command.
Parameters
interval
seconds
Defaults Disabled
Command CONFIGURATION
Modes
Command
Version 8.3.16.1
History
Usage To enable polling and to configure the polling frequency, use this command.
Information
86
Introduced the support for roles on the MXL 10/40GbE
Switch.
Introduced on the MXL 10/40GbE Switch IO Module.
NOTE: If you are authorized for the EXEC privilege mode by your role, you do
not need to enter an enable password.
— configures a password for the enable command and to
Enter the keyword interval then the polling interval in
seconds. The range is from 120 to 6000 seconds. The
default is 300 seconds (5 minutes).
Replaces the enable xfp-power-updates command.
Control and Monitoring