Upgrade Boot - Dell MXL 10GbE Reference Manual

Lines Beginning
With
Chassis Type:
Control
Processor:...
128K bytes...
1 34 Port

upgrade boot

Upgrade the bootflash image or bootselector image.
Syntax
upgrade boot {all | bootflash-image | bootselector-image}
stack-unit {0-5 | all} {booted | flash: |ftp: | tftp: |
usbflash:} (A: | B:}
Parameters
all
bootflash-
image
bootselector-
image
0–5
all
booted
ftp:
tftp:
flash:
74
Description
Chassis type (for example, E1200, E600, E600i, E300, C300,
C150, S25, S50, S55, S60, S4810)
Control processor information and amount of memory on
processor
Amount and type of memory on system
Hardware configuration of the system, including the
number and type of physical interfaces available
Enter the keyword all to change both the bootflash and
bootselecter images.
Enter the keywords bootflash-image to change the
bootflash image.
Enter the keywords bootselector-image to change the
bootselector image.
Enter the keyword 0–5 to upgrade all stack-units.
Enter the keyword all to upgrade all the member stack-
units.
Enter the keyword booted to upgrade from the current
image in the MXL 10/40GbE Switch.
After entering the keyword ftp:, you can either follow it
with the location of the source file in this form: //
userid:password@hostip/filepath or press Enter to
launch a prompt sequence.
After entering the keyword tftp:, you can either follow it
with the location of the source file in this form: //
hostlocation/filepath or press Enter to launch a
prompt sequence.
After entering the keyword flash:, you can either follow it
with the location of the source file in this form: //filepath
or press Enter to launch a prompt sequence.
File Management