Interface Loopback - Dell Z9500 Reference Manual

Version
7.6.1.0
7.5.1.0
6.4.1.0
Usage
You cannot delete a physical interface.
Information
By default, physical interfaces are disabled (shutdown) and are not assigned to an
IP address or switchport. To place an interface in Layer 2 mode, ensure that the
interface's configuration does not contain an IP address and enter the switchport
command.
You can create up to 64 tunnel interfaces. The tunnel is added as a logical interface
with no default configuration. To delete a tunnel interface, use the no interface
tunnel tunnel-id command.
Example
Dell(conf)#int tengigabitethernet 0/0
Dell(conf-if-te-0/0)#exit
Dell(conf)#
Related

interface loopback

Commands
interface null
interface port-channel
interface vlan
show interfaces
interface loopback
Configure a Loopback interface.
Z9500
Syntax
interface loopback number
To remove a loopback interface, use the no interface loopback number
command.
Parameters
number
Defaults Not configured.
Interfaces
Description
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
— configures a Loopback interface.
— configures a Null interface.
— configures a port channel.
— configures a VLAN.
— displays the interface configuration.
Enter a number as the interface number. The range is from 0
to 16383.
813