Interface Loopback - Dell S6000 Reference Manual

Command line for the system
Hide thumbs Also See for S6000:
Table of Contents

Advertisement

Command
CONFIGURATION
Modes
Command
Version 9.4(0.0)
History
Usage
The interface group command will create all the non-existent VLANs specified
Information
in the range. On successful command execution, the CLI switches to the interface
group context.
The configuration commands inside the group context will be the similar to that of
the existing range command.
Note: For release 9.4(0.0), the group command is supported only for VLANs and
physical interfaces.
Example
Dell(conf)#interface group ?
fortyGigE
gigabitethernet
tengigabitethernet
vlan
Dell(conf)# interface group vlan 1 - 2 , tengigabitethernet
0/0
Dell(conf-if-group-vl-1-2,te-0/0)# no shutdown
Dell(conf-if-group-vl-1-2,te-0/0)# end

interface loopback

Configure a Loopback interface.
S6000
Syntax
interface loopback number
To remove a loopback interface, use the no interface loopback number
command.
Interfaces
gigabitethernet 0/1 - 5 ; interface group
gigabitethernet 0/1-5.
For a Gigabit Ethernet interface, enter the keyword
gigabitethernet then the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Introduced on the S4810, S4820T, S6000, Z9000, and MXL
Switch.
FortyGigabit Ethernet interface
GigabitEthernet interface IEEE 802.3z
TenGigabit Ethernet interface
VLAN keyword
641

Advertisement

Table of Contents
loading

Table of Contents