Qos-Policy-Output - Dell Force10 Z9000 Reference Manual

Related rate police
Commands

qos-policy-output

Create a QoS output policy.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax qos-policy-output qos-policy-name
To remove an existing output QoS policy, use the no qos-policy-output qos-
policy-name command.
Parameters
qos-policy-name
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 7.6.1.0
pre-Version
6.1.1.1
Usage
Use this command to specify the name of the output QoS policy. After the output policy is
Information
specified, rate-limit, bandwidth-percentage, and WRED can be defined. This command enables
Qos-Policy-Output Configuration mode—(conf-qos-policy-out).
When changing a service-queue configuration in a QoS policy map, all QoS rules are deleted
and re-added automatically to ensure that the order of the rules is maintained. As a result, the
Matched Packets value shown in the show qos statisticscommand is reset.
Related
rate limit
Commands
bandwidth-percentage
bandwidth-weight
wred
– incoming traffic policing function.
Enter your output QoS policy name in character format (32 characters
maximum).
Introduced on the Z9000.
Introduced on the S4810.
Policy name character limit increased from 16 to 32.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
– outgoing traffic rate-limit functionality.
– assigns weight to the class/queue percentage.
– assigns a priority weight to a queue.
– assigns yellow or green drop precedence.
1205