Rate Shape - Dell Force10 Z9000 Reference Manual

Defaults Granularity for commited-rate and peak-rate is Mbps unless you use the kbps option.
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1
Usage
Information
C-Series and S-Series
On one interface, you can configure the rate police command for a VLAN or you can
configure the rate police command for an interface. For each physical interface, you can
configure three rate police commands specifying different VLANS.
E-Series
On one interface, you can configure the rate limit or rate police command for a
VLAN or you can configure the rate limit or the rate police command for the
interface.
For each physical interface, you can configure six rate police commands specifying
different VLANS.
After configuring VLANs in the rate police command, if this error message appears:
%Error: Specified VLANs overlap with existing config. check to see if
the same VLANs are used with the rate limit command on other interfaces. To clear the
problem, remove the rate limit configuration(s), and re-configure the rate police
command. After the rate police command is configured, return to the other interfaces
and re-apply the rate limit configuration.
Related
rate-police
Commands

rate shape

Shape the traffic output on the selected interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax rate shape [kbps] rate [burst-KB]
Introduced on the Z9000.
Introduced on the S4810.
Added the kbps option on the C-Series, E-Series, and S-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
NOTE: Per Port rate limit and rate police is supported for Layer 2 tagged and untagged
switched traffic and for Layer 3 traffic. Per VLAN rate limit and rate police is supported on
only tagged ports with Layer 2 switched traffic.
– specifies traffic policing on the selected interface.
1185