Neighbor Route-Map - Dell S6000 Reference Manual

Parameters
ip-address
peer-group-
name
Defaults Disabled (that is, private AS number are not removed).
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
Applies to EBGP neighbors only.
Information
Configure your system to accept 4-byte formats before entering a 4 byte AS
Number.
If the AS-PATH contains both public and private AS number or contains AS
numbers of an EBGP neighbor, the private AS numbers are not removed.
If a confederation contains private AS numbers in its AS-PATH, the software
removes the private AS numbers only if they follow the confederation numbers in
the AS path.
Private AS numbers are from 64512 to 65535 (2 byte).

neighbor route-map

Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
S6000
Syntax
neighbor {ip-address | peer-group-name} route-map map-name {in
| out}
Border Gateway Protocol
Enter the IP address of the neighbor to remove the private AS
numbers.
Enter the name of the peer group to remove the private AS
numbers.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series. Added 4-byte support.
379