Neighbor Activate - Dell S6000 Reference Manual

neighbor activate

This command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI (Address
Family Identifier/Subsequent Address Family Identifier).
S6000
Syntax
neighbor [ip-address | peer-group-name] activate
To disable, use the no neighbor [ip-address | peer-group-name]
activate command.
Parameters
ip-address
peer-group-
name
activate
Defaults Disabled
Command CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage By default, when you create a neighbor/peer group configuration in the Router
Information BGP context, this enables IPv4/Unicast AFI/SAFI. When you use activate in the
new context, the neighbor/peer group enables for AFI/SAFI.
It is not possible to de-activate a peer from the IPv4 unicast address family.
Border Gateway Protocol
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
(OPTIONAL) Enter the name of the peer group.
Enter the keyword activate to enable the neighbor/peer
group in the new AFI/SAFI.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
361