Ip Tftp Source-Interface - Dell C9000 Series Reference Manual

Defaults The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.5.1.0
8.2.1.0
8.1.1.0
7.6.1.0
7.5.1.0
E-Series
Related telnet
Commands

ip tftp source-interface

Assign an interface's IP address in outgoing packets for TFTP traffic.
C9000 Series
Syntax
ip tftp source-interface interface
• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on ExaScale.
Increased number of VLANs on ExaScale to 4094 (was 2094).
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Original command
— telnets to another device.
Control and Monitoring 101