Ip Tftp Source-Interface - Dell S4810 Reference Manual

Hide thumbs Also See for S4810:

Table of Contents

If you configure a TELNET client to use a specific VRF, then you need not explicitly

specify the same VRF during the TELNET client sessions corresponding to that VRF.

FTOS(conf)#ip telnet vrf vrf1

FTOS(conf)#do telnet 10.10.10.2

FTOS(conf)#no ip telnet vrf vrf1

ip tftp source-interface

Assign an interface's IP address in outgoing packets for TFTP traffic.

ip tftp source-interface interface

To return to the default setting, use the no ip tftp source-interface

interface command.

The IP address on the system that is closest to the Telnet address is used in the

outgoing packets.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Control and Monitoring

Enter the following keywords and slot/port or number

information:

For Loopback interfaces, enter the keyword loopback

then a number from zero (0) to 16383.

For a Port Channel, enter the keyword port-channel

then a number. For the C-Series and S-Series, the range

is 1 to 128.

For the SONET interfaces, enter the keyword sonet then

slot/port information.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

Introduced on the S4820T.