Avaya DEFINITY Server CSI Maintenance Manual page 48

Maintenance for CSI systems
Reset System 1 (System Warm Start)
This recovery takes about 30 seconds. All stable phone calls remain up.
In-progress calls are dropped. No new calls can be made during this time.
In this restart, all software (Oryx/Pecos, drivers, maintenance, and so forth.) is
reset and the following appears:
RESET 1 (WARM) PERFORMED
Reset System 2 (System Cold Start
Without Translations Loading)
In this restart, all software (Oryx/Pecos, drivers, maintenance, and so forth) is
reset. In addition, the TDM Bus and all port circuit packs are reset. All Port circuit
packs are reset. All telephone sessions are dropped. Telephones begin to
reconnect to the switch within 30 seconds. In a large system, reconnection of all
telephones may take up to five minutes. Typical displays are:
INTERNAL REGISTER TEST
LOCAL BUS TEST
ROM CHECKSUM TEST
CONTROL STATUS TEST
DCACHE TEST
ICACHE TEST
WRITE BUFFER TEST
BTO TEST
TIMER TEST
RESET 2 (COLD_2)PERFORMED
Reset System 3 (System Cold Start
With Translations Loading)
In this restart, all software (Oryx/Pecos, drivers, maintenance, and so forth) is
reset. After the software is reset, all translations load from translation card. In
addition, the TDM Bus and all port circuit packs are reset. Emergency Transfer is
invoked. Translations reload from translation card. Depending on the translations,
the reloading process could take from five to 30 seconds. Thereafter, all port
circuit packs are reset, and all telephone sessions drop. Telephones begin to
reconnect to the switch within 30 seconds. In a large system, reconnection of all
telephones may take up to five minutes. Typical displays are as follows:
INVOKING EMERGENCY TRANSFER
INTERNAL REGISTER TEST
LOCAL BUS TEST
ROM CHECKSUM TEST
CONTROL STATUS TEST
DCACHE TEST
ICACHE TEST
48
Issue 5 October 2002
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
555-233-119