Match Ip Address - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

match ip address

match ip address { accessListName [ accessListName ]* |
Syntax
prefix-list prefixListName [ prefixListName ]* | prefix-tree treeName [ treeName ]* }
no match ip address [ accessListName ]* | prefix-list [ prefixListName ]* |
prefix-tree [ treeName ]*
Command introduced before JUNOSe Release 7.1.0.
Release Information
Matches any routes that have a destination network number address that is permitted
Description
by a standard or extended access list, a prefix list, or a prefix tree, or performs policy
routing on packets. You cannot mix references in the same match command; you
can only specify either access list(s), prefix list(s), or prefix tree(s). The no version
removes the match clause from a route map unless you specify a value, in which
case only that value is removed from the match clause.
Options
Policy List Configuration, Route Map Configuration
Mode
1262
match ip address
accessListName—String of up to 32 alphanumeric characters
prefixListName—Name of a single prefix list; string of up to 32 characters
treeName—Name of a single prefix tree; string of up to 32 characters
* Indicates that one or more parameters can be repeated multiple times in a
list in the command line