Area Virtual-Link Authentication Message-Digest - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
area virtual-link authentication message-digest
Syntax
Release Information
Description
Options
Mode
134
[ no ] area { areaID | areaIdInt } virtual-link ipAddress authentication message-digest
Command introduced before JunosE Release 7.1.0.
Specifies that MD5 authentication is used for the virtual link. The no version sets the
authentication for the virtual link to none, but leaves any configured MD5 key intact.
areaId—OSPF area ID in IP address format
areaIdInt—OSPF area ID as a decimal value in the range 0–4294967295
ipAddress—IP address of the virtual link neighbor
Router Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
