Show Ip Dvmrp Route - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ip dvmrp route

Displays the DVMRP routes that are being advertised to other routers.
show ip dvmrp route [ip_address ip_mask]
Syntax Definitions
ip_address
ip_mask
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
If a source IP address and IP mask are not specified, the entire DVMRP route table is displayed.
Examples
-> show ip dvmrp route
Legends: Flags:
Address/Mask
-------------------+------------------+------+-----------+---------+-----
11.0.0.0/8
22.0.0.0/8
44.0.0.0/8
55.0.0.0/8
66.0.0.0/8
output definitions
Address/Mask
Gateway
Metric
Age
page 29-36
The 32-bit source IP address representing route(s).
A 32-bit number that determines the subnet mask for the IP address.
L = Local, R = Remote, F = Flash, H = Holddown, I = Invalid
Gateway
55.0.0.5
44.0.0.4
-
-
44.0.0.4
The 32-bit IP address for the router interface, along with the corre-
sponding subnet mask. The interface's subnet mask is shown using the
CIDR prefix length: 255.0.0.0 equals /8; 255.255.0.0 equals /16;
255.255.255.0 equals /24, etc.
The corresponding 32-bit gateway address. Because it is not applicable,
no gateway address is displayed for local routes.
The current metric value. A metric is essentially used to determine the
most cost-effective way to pass data through the network. The higher
the metric value, the higher the cost.
The current age of the DVMRP route, displayed in hours, minutes, and
seconds.
Metric Age
2 00h:13m:14s
2 00h:33m:14s
1 05h:24m:59s
1 05h:24m:59s
2 00h:03m:11s
OmniSwitch CLI Reference Guide
DVMRP Commands
Expires Flags
02m:07s R
02m:15s R
- L
- L
02m:15s R
June 2012