Ip Pim State-Refresh-Interval - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip pim state-refresh-interval

Sets the interval between successive State Refresh messages originated by a router.
ip pim state-refresh-interval seconds
Syntax Definitions
seconds
Defaults
parameter
seconds
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command is supported only in the dense mode.
•
This value is used with both IPv4 PIM-DM and IPv6 PIM-DM.
Examples
-> ip pim state-refresh-interval 80
Release History
Release 6.1.1; command was introduced.
Related Commands
ip pim interface
ipv6 pim interface
show ip pim dense
show ipv6 pim dense
MIB Objects
alaPim
alaPimRefreshInterval
page 30-26
The interval between successive State Refresh messages, in seconds.
Values may range from 0 to 65535.
default
60
Enables or disables the PIM protocol on a specific interface.
Enables IPv6 PIM and configures the statistics.
Displays the status of the various global parameters for the PIM
dense mode.
Displays the status of the various global parameters for the IPv6
PIM dense mode.
OmniSwitch CLI Reference Guide
PIM Commands
June 2012