Ip Pim Interface - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

PIM Commands

ip pim interface

Enables PIM and configures PIM-related statistics such as hello-interval, triggered-hello, hello-holdtime,
joinprune, prune-delay, override-interval, dr-priority, stub interface, prune limit interval, and graft retry
interval on the interface.
ip pim interface if_name [hello-interval seconds] [triggered-hello seconds] [joinprune-interval
seconds] [hello-holdtime seconds] [joinprune-holdtime seconds] [prune-delay milliseconds] [override-
interval milliseconds] [dr-priority priority] [[no] stub] [prune-limit-interval seconds] [graft-retry-
interval seconds]
no ip pim interface if_name
Syntax Definitions
if_name
hello-interval seconds
triggered-hello seconds
joinprune-interval seconds
hello-holdtime seconds
joinprune-holdtime seconds
prune-delay milliseconds
override-interval milliseconds
dr-priority priority
prune-limit-interval seconds
graft-retry-interval seconds
stub
OmniSwitch CLI Reference Guide
The interface name on which PIM is being enabled or disabled.
The frequency at which PIM Hello messages are transmitted on a speci-
fied interface, in seconds. Values may range from 0 to 18000.
Specifies the maximum time, in seconds, before a triggered PIM Hello
message is sent on this interface. Values may range from 0 to 60.
The frequency at which periodic Join/Prune messages are sent on this
interface, in seconds. Values may range from 0 to 18000.
Specifies the value set in the Holdtime field of PIM Hello messages sent
on this interface, in seconds. Values may range from 0 to 65535.
Specifies the value inserted into the Holdtime field of the Join/Prune
messages sent on this interface, in seconds.Values may range from 0 to
65535.
Specifies the value of the expected propagation delay between PIM
routers on this network, inserted into the LAN prune-delay option of the
Hello messages sent on this interface, in milliseconds. Values may
range from 0 to 32767.
Specifies the value inserted into the Override Interval field of the LAN
prune-delay option of the Hello messages sent on this interface, in milli-
seconds. Values may range from 0 to 65535.
Specifies the Designated Router priority inserted into the DR priority
option on a specified interface. The DR priority option value can range
between 1 to 192. A higher numeric value denotes a higher priority.
Specifies the minimum interval that must elapse between two succes-
sive prune messages sent on this interface, in seconds. Values may
range from 0 to 65535.
Specifies the minimum interval that must elapse between two succes-
sive graft messages sent on this interface, in seconds. Values may range
from 0 to 65535.
Specifies the interface not to send any PIM packets via this interface,
and to ignore received PIM packets.
June 2012 page 30-29