Tunnel Local - 3Com 3C13618 Command Reference Manual

3Com Command Reference Guide — V1.00
Parameter
ah-new: Using the AH protocol specified in RFC2402.
ah-esp-new: Using the ESP and then AH on packets.
esp-new: Using the ESP protocol specified in RFC2406.
Description
Using the transform command, you can configure a security protocol used by a
proposal set. Using the undo transform command, you can restore the default
value.
By default, the setting is esp-new, that is, the ESP protocol specified in RFC2406.
This command is applicable to the IPSec module of the operating system and crypto
card.
The proposal sets used by the IPSec policy set at both ends of the security tunnel
must be set as having the same security protocol.
For related commands, see ipsec proposal, ipsec policy (system view), ipsec
policy (interface view), security acl, tunnel local, tunnel remote, sa
inbound/outbound.
Example
# Configure a proposal set using AH.
[3Com]ipsec proposal trans1
[3Com-ipsec-proposal-trans1]transform ah-new

4.1.42 tunnel local

Syntax
tunnel local ip-address
undo tunnel local
View
IPSec policy view
Parameter
ip-address: Local address.
86