Reset Fr Inarp-Info - 3Com 3C13618 Command Reference Manual

Parameter
bandwidth-percentage: The maximum percentage of the available bandwidth used by
the virtual circuit, in the range of 1 to 100.
Description
Using the reserved-bandwidth command, you can configure the maximum available
bandwidth
reserved-bandwidth command, you can cancel the maximum available bandwidth
used by the Frame Relay virtual circuit.
By default, no maximum available bandwidth used by the virtual circuit is configured.
After the traffic shaping is enabled on the virtual circuit, if congestion occurs, the
sending rate of the virtual circuit will be reduced to CIR × bandwidth-percentage. After
the congestion is relieved, the sending rate will be restored to CIR.
For related commands, see cir allow, fr traffic-shaping.
Example
# Set the maximum available bandwidth of the Frame Relay virtual circuit to 85%.
[3Com-fr-class-frts]reserved-bandwidth 85

6.1.59 reset fr inarp-info

Syntax
reset fr inarp-info
View
System view
Parameter
None
Description
Using the reset fr inarp-info command, you can reset dynamically created Frame
Relay maps.
In some special circumstances, the change of the network architecture will cause the
failure of the dynamic Frame Relay map that originally created and it is necessary to
create it again. You can use this command to clear all the dynamically created maps.
For related commands, see fr inarp.
Example
# Clear all the contents in the Frame Relay dynamic map table.
used by the Frame Relay virtual circuit.
Link Layer Protocol
Using the undo
137