Isdn Qsig-Timer - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00
When this command is used in system view, it can set the default signaling for the ISDN
PRI interface newly created on a router, but it will not affect the type of signaling on the
existing ISDN PRI interface.
When this command is used in interface view, it can set the type of signaling for the
active ISDN PRI interface. However, if there are calls on the interface, configuring this
command will not take effect. In this case, you can modify the signaling type for the
interface only after all the calls on the interface are disconnected or manually cleared
by executing the commands shutdown and undo shutdown.
For related commands, see display isdn call-info.
Example
# Configure the router 3Com to use QSIG signaling at the interface Serial2:15.
[3Com-Serial2:15]isdn protocol-type qsig

4.1.11 isdn qsig-timer

Syntax
isdn qsig-timer timer-name time-interval
undo isdn qsig-timer { timer-name | all }
View
Interface view
Parameter
timer-name: Name of QSIG timer. Refer to the following table for description in detail.
time-interval: Interval of timer. Refer to the following table for description in detail.
all: To be used to restore the default interval values of all the QSIG timers.
Description
Using the isdn qsig-timer command, you can configure the interval for a QSIG
signaling timer. Using the undo isdn qsig-timer command, you can restore the default
interval values of QSIG signaling timers.
Different timers have different default values. Refer to the following table for description
in detail.
When QSIG signaling is adopted on an ISDN PRI interface, users can customize the
interval values of timers as needed. Executing the undo isdn qsig-timer all command
will restore the default interval values of all the QSIG timers.
38