Display Debugging - 3Com 3C13618 Command Reference Manual

Example
# Enable the IP Packet debugging.
[3Com] debugging ip packet
IP packet debugging switch is on.

4.1.2 display debugging

Syntax
display debugging
View
All views
Parameter
None
Description
Using the display debugging command, you can view the debug switches that have
already been turned on.
To check which debug switches have been turned on, you can execute the display
debugging command. Debug switches are shown in two parts: a) link-layer debug
switches already turned on are shown according to the order of the interfaces, which
are valid to interfaces only; b) global debug switches.
For related commands, see debugging.
Example
# Display the debugging already enabled.
[3Com] display debugging
Enable pimsm J/P TIMER debugging functions
Enable bridge packet debugging functions.
Enable spanning-tree protocol packet debugging functions.
Enable spanning-tree protocol event debugging functions.
Enable spanning-tree protocol error debugging functions.
Enable VRRP packet debugging functions.
Enable VRRP state debugging functions.
Enable RAW IP debugging functions.
Enable X25 XOT Packet debugging functions
System Management
67