3Com 3C13618 Command Reference Manual page 277

3Com Router Command Reference Guide — V1.00
For related commands, see x25 timer tx0, x25 timer tx2, x25 timer tx3.
Example
# Set the timer delay on the X.25 channel interface serial0 to 100 seconds.
[3Com-Serial0]x25 timer tx1 100
5.1.48 x25 timer tx2
Syntax
x25 timer tx2 seconds
undo x25 timer tx2
View
Interface view
Parameter
seconds: Delay value of the reset indication retransmission timer in second.
Description
Using the x25 timer tx2 command, you can configure the delay value for reset
indication retransmission timer on a DTE/DCE. Using the undo x25 timer tx2
command, you can restore to the default value.
Default value for the reset request retransmission timer on a DTE is 180 seconds;
default value for the reset request retransmission timer on a DCE is 60 seconds.
According to X.25, a timer should be started when a DTE sends a reset request (or a
DCE sends a reset indication). If no remote acknowledgement is received after this
timer is timeout, the sending end will take some measures to guarantee the normal
proceeding of the local procedure. This parameter specifies the delay value of this timer
before the timeout.
For related commands, see x25 timer tx0, x25 timer tx1, x25 timer tx3.
Example
# Set the reset timer delay on the X.25 channel interface serial0 to 120 seconds.
[3Com-Serial0]x25 timer tx2 120
5.1.49 x25 timer tx3
Syntax
x25 timer tx3 seconds
undo x25 timer tx3
84