X25 Response Calling-Address - 3Com 3C13618 Command Reference Manual

3Com Router Command Reference Guide — V1.00
For related commands, see x25 response calling-address, x25 ignore
called-address, x25 ignore calling-address.
Example
# Specify that the input packet of a call sent from the X.25 interface Serial0 carries the
called DTE address.
[3Com-Serial0]x25 response called-address

5.1.35 x25 response calling-address

Syntax
x25 response calling-address
undo x25 response calling-address
View
Interface view
Parameter
None
Description
Using the x25 response calling-address command, you can configure the calling
DTE address field in outgoing calls while X.25 sends the call input packet. Using the
undo x25 response calling-address command, you can reset this command to its
default value.
By default, this function is disabled.
According to X.25, the input packet of a call may or may not carry an address code
group, depending on the specific network requirements. This command enables you to
easily specify whether the input packet of a call sent by X.25 of the 3Com series routers
carries the calling DTE address.
For related commands, see
called-address, x25 ignore calling-address.
Example
# Specify that the input packet of a call sent from the X.25 interface Serial0 carries the
calling DTE address
[3Com-Serial0]x25 response calling-address
72
x25 response called-address, x25 ignore