Tcp Timer Fin-Timeout - 3Com 3C13618 Command Reference Manual

When running PPP in the lines of low speed WAN, the TCP header accounts for a
large proportion of the data being transmitted, therefore TCP header compression
can be used to improve the efficiency of data transmission.
For related commands, see link-protocol ppp.
Example
# Enable TCP header compression at the PPP interface Serial0.
[Quidway-Serial0] ppp compression vj

3.2.3 tcp timer fin-timeout

Syntax
tcp timer fin-timeout seconds
View
System view
Parameter
seconds: Value of the TCP finwait timer in seconds, ranging from 76 to 3600 seconds.
The default value is 675 seconds.
Description
Using the tcp timer fin-timeout command, you can configure the TCP finwait timer.
Start the finwait timer when the connection status changes from FIN_WATI_1 to
FIN_WAIT_2. If no FIN message is received before the finwait timer is timed out, the
TCP connection will be terminated.
This parameter should be configured under the guidance of the technical support
engineer.
For related commands, see tcp timer syn-timeout, tcp window.
Example
# Set the value of the TCP finwait timer to be 675 seconds.
[Quidway] tcp timer fin-timeout 675
Network Protocol
57