X25 Alias-Policy - 3Com 3C13618 Command Reference Manual

Example
# Clear a XOT link.
[3Com]reset xot remote 10.1.1.2 1024 local 10.1.1.1 1998

5.1.20 x25 alias-policy

Syntax
x25 alias-policy match-type alias-string
undo x25 alias-policy match-type alias-string
View
Interface view
Parameter
match-type match type of the alias. The optional match types include:
free: free match
free-ext: extended free match
left: left alignment match
left-ext: extended left alignment match
right: right alignment match
right-ext: extended right alignment match
strict: strict match
whole: whole match
whole-ext: extended whole match
alias-string string of the alias
Description
Using the x25 alias-policy command, you can configure an X.12 alias address. Using
the undo x25 alias-policy command, you can cancel an X.12 alias address.
By default, no X.25 alias is configured.
When an X.25 call is forwarded between networks, different X.25 networks may
perform some operations on the destination addresses (that is, the called DTE address)
carried by this call packet, for example, routinely adding or deleting the prefix and suffix.
In this case, you need to set an interface alias for the router to adapt to this change.
Please consult your ISP to learn if the network supports this function before deciding if
the alias function is enabled or not.
For the detail about the X.25 alias matching method, please consult the chapter
"Configuring LAPB, X.25, X.25 Switching, and XOT" in the manual of Configuration
Guide.
For related commands, see display x25 alias-policy, x25 x121-address.
Link Layer Protocol
57